If so, this rock-solid Bantam Multi-Angle Mount is a great solution. It easily attaches via a removable 3M VHB Adhesive and it can be rotated and firmly set to literally thousands of possible angles for optimum viewing of your Garmin GPS receiver.

Great design, small footprint, and very handy! The Multi Angle Mount includes one (1) 3M VHB adhesive, One large Case Tab with removable adhesive and alcohol wipes to clean your dash mounting surface.

How to install a replacement car mount for your Garmin GPS receiver.

1. Clean the back of your GPS with the enclosed alcohol pads. 
   
2. Apply the adhesive to the Case Tab first, then remove the remaining paper.
   
3. Apply the rectangular Case Tab as shown below.  We found this exact spot was perfect for our Garmin nüvi 200W. REMEMBER: The enclosed 3M VHB is NOT GLUE and IT IS REMOVABLE. Press firmly.
   
4. Clean the dash or your vehicle with the enclosed alcohol pads to remove ALL TRACES of ArmorAll, or similar substances. Nothing sticks well to a surface treated with those products.
   
5. Install the GPS receiver into the Multi-Angle Mount and do a test install (no adhesive yet) to find your optimum location. Make your initial adjustments with a phillips head screwdriver to make it easier.
   
6. Remove one side of the Multi-Angle Mount adhesive and place it on the bottom of your mount.
   
7. Remove the remaining paper from the adhesive and place into position. Press firmly and allow to cure for at least 8 hours.